|
|
Testing is the Control
Testing is part of a detailed check and balance system which validates the total
quality manufacturing environment. We test our products and the materials used in
their fabrication with the following equipment:
- Environmental Test Chamber
|
M-Tek's environmental test chamber evaluates product resilience to controlled environmental
conditions. Testing is possible under such conditions as constant temperature, or
long-term cyclic testing at variable temperatures between -40 degrees Celsius and
100 degrees Celsius with humidity as high as 95 percent.
|
|
- Color Measuring Computer
|
Using our MacBeth Color-Eye system, M-Tek's trained staff inspects the color consistency
of both incoming raw materials and our injection molded products. Most importantly,
all colored parts are evaluated within a very narrow range to assure accurate match
with approved color standards.
|
|
- Three-Dimensional Layout Machine
|
The Coordinate Measurement Layout Machine (CMM) supports three-axis measurements
of <.05mm serving M-Tek's product design needs, as well as customer requirements
for accurate dimensional information.
|
|
- Sunshine Weather-o-meter
- Flammability Tester
- High-Temperature Testing Oven
- Color Chamber
- Shopper Type Tensile Tester
|
|